![]() WARNING: Cloths saturated with product are a spontaneous combustion hazard and should be left out unfolded until dried, prior to disposal or preferably stored in a proper fireproof container. ![]() Floors and Tabletops) we suggest to apply the coating using the Brush or Roller technique. Walnut) it may not be possible to achieve full durability and stain resistance when applying with a cloth. NOTE: Depending upon the species of wood (ie. Apply subsequent coats following previous steps.Allow 8-10 hours drying time prior to recoating.Working with the grain, remove all excess product from surface.Allow roughly 15-minutes for oils to penetrate.Work product into wood using cloth in a circular or figure 8 pattern.NOTE: For high quality finishes on items like tabletops, a smoother result can be achieved by lightly sanding the surface after the second coat has fully dried with P320 or P400 grit sandpaper, and then buffing in 1-2 coats with a cloth or white pad.Īpply 4-6 thin coats with a lint-free microfibre cloth. Please consult OSMO technical support at 1-844-OSMOCAN prior to carrying out a third coat Third Coat: Usually a third coat is not required, however highly absorbent or dry timbers may appear to require a third coat. Allow for good ventilation whilst drying. Allow approximately 5-10 minutes for product to penetrate surface. ![]() Brush or roll the second coat thinly and evenly onto the floor.Second Coat: Roll or Brush a thin second coat Allow 8-10 hours drying time prior to proceeding to second coat.Do not remove excess product, this will absorb into the wood surface over the drying period.Brush or roll the product thinly and evenly onto the floor.Perfect for species such as Teak, Cedar, Iroko and Mahogany etc. Stir the Polyx®-Oil well and prior to use Osmo Wood Wax Finish Extra Thin - a clear natural oil and wax finish for interior use.We recommend allowing 2-3 weeks for the surface to fully cure and harden prior to damp-mopping or placing rugs/mats on the surface.įirst Coat: Apply one thin coat with an Osmo Floor Brush or Osmo Floor Roller. Apply second coat and third coats following previous steps.Ĭure Period: Osmo Polyx-Oil(s) like all finishes have a cure period.Be sure to thinly and evenly coat the surface.Work the product into the wood thinly and evenly using the fleece applicator pad.Stir the Polyx®-Oil well and pour into tray.Apply 2-3 thin coats with our fleece applicator pads (best way to ensure you avoid over-application).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |